Mujer con gorra trucker azul The Indian Face junto a un todoterreno verde

How to choose a cap based on your head size

BEFORE CHOOSING

The fit starts with a measuring tape

To find out what cap size you need, measure your head circumference above your eyebrows and ears. Look up that measurement in the model's size guide, then check where the cap's edge sits. If the band leaves a mark on your forehead or the sides rub against your ears, changing the closure position will only solve one of those problems.

CircumferenceThe measurement in centimeters around the head.
CrownThe part that covers the head and determines how far down the edge sits.
ClosureThe available range for tightening or loosening.

FIT GUIDE

What to check before choosing

Detail How to check
Circumference Measure around your head and compare the centimeters with the model's range.
Crown depth Look from the side to see how much space there is between the edge and the top of your ear.
Back closure Check whether you have room to tighten and loosen it from your usual position.
Stability Tilt and turn your head. The cap should stay in place while the band feels comfortable.

MEASUREMENT

How to Measure Your Head for a Cap

Stand in front of a mirror with your hair styled as usual. If you normally tie it back, try the same hairstyle you'd wear with the cap.

  1. Place a flexible tape about one finger above your eyebrows.
  2. Pass it over your ears and around the back of your head. Check in the mirror that the tape isn't tilted or twisted.
  3. Bring the ends together without pulling tight. Note the result in centimeters and repeat the measurement from the beginning.

If you don't have a measuring tape, you can wrap a non-stretchy cord around your head. Mark where the ends meet and measure that section with a ruler.

Measurement guide for head circumference and snapback adjustment
Place the tape above your eyebrows and check that it stays at the same height on both sides.
Man wearing a green trucker cap on a road beside the forest
Born to be Free Green / Beige Cap by The Indian Face.

SIZE AND CIRCUMFERENCE

Which Cap to Choose if You Have a Large or Small Head

Use your measurement to read the model’s adjustment range. For example, if your head measures 58 cm and a product listing gives a range of 56–60 cm, you can adjust the cap on either side of your measurement. This is an example of how to read the range. Each model has its own measurements.

If this happens What to try
The band presses against your forehead when the closure is at its loosest. Look for a model with a larger maximum circumference.
The cap turns even when the closure is at its tightest. Look for a model with a smaller minimum circumference.
It fits you at the last closure position. Try a model with room to loosen or tighten.

If the product listing only says “one size,” look for the closure type and check the minimum and maximum circumference if you often have trouble finding the right size. If you already have a comfortable cap, leave it adjusted to your usual position and measure the inside of its band with a flexible tape measure. You can also use that measurement to compare two caps at home.

CROWN HEIGHT

How to tell if your cap’s crown is too deep

Try it on with the closure in a comfortable position and look at yourself in profile. If the band sits securely on your forehead but the side comes down over the top of your ear, try a shallower crown. If the top of your head touches the inside before the band sits in place, try a deeper crown.

On a trucker cap, the mesh is part of the back construction. To assess the fit, also look at the model’s profile and how the band sits along the sides. If you wear glasses, try them on together and check that the cap doesn’t push against the temples.

Man in profile wearing a green cap and sunglasses in a car
Check where the side edge of the cap sits in relation to your ear.

QUICK TEST

Tilt your head forward

After adjusting the closure, look down and turn your head from side to side. If the cap shifts, try a tighter position. If it stays in place but presses against your forehead, check the circumference or try a different crown shape.

BACK ADJUSTMENT

How to adjust a cap’s snapback closure

The snapback closure has two plastic strips. One has holes and the other has pegs. Overlap the strips and press until the corresponding pegs snap into place. Start with a comfortable position and move one notch at a time until the cap feels secure.

If you open it so far that the closure comes undone when you move your head, try a wider range. If one position is loose and the next is too tight, a sliding strap may allow a finer adjustment.

To compare closure types, explore the cap collection and look at the photos of the back.

Green Born to be Free cap with beige mesh next to a can on wood
Curved brim, green front, and beige mesh on the Born to be Free Green / Beige.

WHEN TRYING IT ON

Three mistakes when choosing a cap

Measuring with the tape too tight

The measurement will come out smaller and may put you at the limit of a cap’s adjustment range. Let the tape rest against your skin without compressing it.

Adjusting the closure to fix rubbing against your ear

If it still rubs when the band fits comfortably, try a different crown depth. Tightening it more could end up leaving a mark on your forehead.

Choosing based only on how it looks from the front

Look at it from the side, too. Check the band’s position, the distance to your ear, and the space for the arms if you wear glasses.

SIZE QUESTIONS

Frequently asked questions about cap fit

What cap size do I need if my head measures 58 cm?

One whose size range includes 58 cm. If the manufacturer uses letter sizes, check the equivalent measurement in centimeters for that model.

Does a one-size cap fit every head?

One size means it comes in a single size. If it has an adjustable closure, its range of adjustment lets it fit a range of sizes. Check that your head circumference falls within that range.

How should a cap fit?

The band should fit snugly without pressing on your forehead. When you look down or turn your head, the cap should stay in place.

How do I know if I need a lower crown?

Try it if the side edge touches your ears even when the band is adjusted properly.

Can I use my hat size to choose a cap?

Use the measurement in centimeters as a starting point. Then check the size chart or range for the specific model and check the crown depth.

What should I do if it fits around my head but keeps moving?

Check where the band rests and whether the crown sits all the way down. Try a different closure position and, if it still moves, compare it with a crown of a different depth.

THE INDIAN FACE

Explore the cap collection

Compare the profiles, brims, and closures of each model with your measurement handy.

EXPLORE CAPS +

← Older post